Graphene Gear Oil Additive

A graphene additive for gear oils, pre-mixed in an oil-based carrier for heavily loaded gear contacts.

  • Patent pending
  • Made in the USA
  • Pre-mixed, never powder
Application
Industrial and automotive gear oils, where meshing teeth run under high contact pressure. Blend into the finished gear oil and test against your baseline.
Carrier
Oil-based: graphene integrated into oleic acid and monomer. Other base oils on request.
Typical dose
Supplied-additive treat guidance: 1–7% by weight; confirm the formulation and dosing basis with GI. Not neat-graphene content.
SKU
GI-GOA-32OZ (32 fl oz bottle)
GI-GOA-1GAL (1 gal jug)
GI-GOA-5GAL (5 gal pail)

Sizes: 32 fl oz bottle, 1 gal jug, 5 gal pail

Request a quote for pricing, lead time and the right dose for your job.

Downloads

Learn more — How to Choose a Graphene Additive: A Buyer's Guide to Graphene Additives by Application →

Patent pending. Made in the USA. Manufacturer: Graphene Integrations, Charlotte, NC.

About this additive

Gear teeth slide and roll under very high contact pressure. Graphene layers between the surfaces can help the oil film carry that load, which is why weld load matters for gear oils: it is the load at which the test surfaces seize.

In independent lab testing, our graphene lubricant additive gave up to 42% smaller four-ball wear-scar diameter and 26% higher weld load. See the full graphene lubricant additive results. Performance in your gear oil depends on the base oil and additive package, so we test in your formulation.

Translate bench protection into a formulation trial

GI’s lubricant additives use graphene integrated into oleic acid and monomer. The 1–7% by-weight treat-rate guidance concerns the supplied additive; agree the dosing basis and carrier for your formulation rather than treating it as neat-graphene content.

Independent four-ball lab testing found up to 42% smaller wear-scar diameter and 26% higher weld load in the tested carrier-fluid blends. These are useful anti-wear and extreme-pressure results, not a measured reduction in engine friction, fuel consumption or maintenance. They do not validate every finished oil or grease.

Compare the finished formulation with its own baseline: viscosity, additive-package compatibility, oxidation, filtration and the relevant wear/load tests. For grease, also check thickener compatibility and consistency; for hydraulics, check air release and pump behavior. Demonstrate any resource benefit with actual oil consumption, replacement parts, drain intervals and energy under matched duty, including additive production and end-of-life in the environmental balance.

Research / measurement reference · Continue with the application guide

Frequently asked questions

Why does weld load matter in gear oil?

Weld load is the load at which the test surfaces seize. In independent lab testing, our graphene lubricant additive raised weld load by 26% and reduced four-ball wear-scar diameter by up to 42%.

Is it compatible with my extreme-pressure additive package?

Compatibility depends on your base oil and additives, so we test in your formulation before any recommendation.

Is the graphene supplied as a powder?

No. It comes pre-mixed in an oil-based carrier, never as dry powder.

How much should I add?

Typical dose: 1–7% by weight, depending on the application. See the technical data sheet. Contact us for a starting treat rate for your testing.

More in Lubricant & Fluid Additives