Graphene Motor Oil Additive

A graphene additive for motor oils, supplied pre-mixed in an oil-based carrier so it blends straight into your oil.

  • Patent pending
  • Made in the USA
  • Pre-mixed, never powder
Application
Motor oil and engine oil formulations: added to the finished oil or blended into your additive package, then tested against your baseline oil.
Carrier
Oil-based: graphene integrated into oleic acid and monomer. Other base oils on request.
Typical dose
Supplied-additive treat guidance: 1–7% by weight; confirm the formulation and dosing basis with GI. Not neat-graphene content.
SKU
GI-MOA-32OZ (32 fl oz bottle)
GI-MOA-1GAL (1 gal jug)
GI-MOA-5GAL (5 gal pail)

Sizes: 32 fl oz bottle, 1 gal jug, 5 gal pail

Request a quote for pricing, lead time and the right dose for your job.

Downloads

Learn more — Graphene Motor Oil: What the Claims Mean and What the Tests Show →

Patent pending. Made in the USA. Manufacturer: Graphene Integrations, Charlotte, NC.

About this additive

Graphene is a sheet of carbon one atom thick. Thin graphene layers can sit between moving metal surfaces and slide over each other, helping the oil keep those surfaces apart under load. This additive brings that into motor oil, ready to blend.

In independent lab testing, our graphene lubricant additive gave up to 42% smaller four-ball wear-scar diameter and 26% higher weld load. Those results come from our graphene lubricant additive testing; engine performance depends on your base oil and additive package, so we test in your formulation. We do not publish fuel-economy, oil-life or field results.

Translate bench protection into a formulation trial

GI’s lubricant additives use graphene integrated into oleic acid and monomer. The 1–7% by-weight treat-rate guidance concerns the supplied additive; agree the dosing basis and carrier for your formulation rather than treating it as neat-graphene content.

Independent four-ball lab testing found up to 42% smaller wear-scar diameter and 26% higher weld load in the tested carrier-fluid blends. These are useful anti-wear and extreme-pressure results, not a measured reduction in engine friction, fuel consumption or maintenance. They do not validate every finished oil or grease.

Compare the finished formulation with its own baseline: viscosity, additive-package compatibility, oxidation, filtration and the relevant wear/load tests. For grease, also check thickener compatibility and consistency; for hydraulics, check air release and pump behavior. Demonstrate any resource benefit with actual oil consumption, replacement parts, drain intervals and energy under matched duty, including additive production and end-of-life in the environmental balance.

Research / measurement reference · Continue with the application guide

Frequently asked questions

What did testing show for graphene in lubricants?

In independent lab testing, our graphene lubricant additive gave up to 42% smaller four-ball wear-scar diameter and 26% higher weld load. Results in a specific motor oil depend on the base oil and additive package, so we test in your formulation.

Is the graphene supplied as a powder?

No. The graphene comes pre-mixed in an oil-based carrier (graphene integrated into oleic acid and monomer), so you add a liquid, not a dry powder.

How much do I add to my oil?

Typical dose: 1–7% by weight, depending on the application. See the technical data sheet. Ask us and we will suggest a starting treat rate for your testing.

Do you claim better fuel economy or longer oil life?

No. We have no measured field data on fuel economy or oil life, so we do not make those claims.

More in Lubricant & Fluid Additives